A Very Canadian Tat-a-long Day 2

Hello and Welcome to Day 2!

A Very Canadian Tat-a-long Day 3

          Vicki Clarke 2024                

victats@gmail.com

 Terms

R- ring

C- chain

SCMR- self closing mock ring

lj- lock join

lp- long picot

mp- mock picot

rw- reverse work.  I will only note this in situations where you don’t normally reverse work

SLT- shoe lace trick

CTM- continuous thread method, do not cut thread between ball and shuttle

 

Materials

Shuttle or needle

Red Thread

 

Wind 1.5 yards on shuttle CTM.  Needle tatters normal tail

 

R             2 +(corner p on Day 1 motif) 2

C             8

R             2 +(base of next ring on Day 1 motif) 2

C             8

R             2 +(next p on Day 1 motif) 2

C             6 vsp 8

R             2 vsp 2

C             6   DNRW

SCMR    6 + (vsp on previous chain) 6  DNRW

C             8

R             3 p 3

C             8 DNRW

SCMR    6 vsp 6 DNRW

C             6

R             2 vsp 2

C             8 +(vsp on previous SCMR)  6 

Join to 1^st chain made, hide ends.

I started with the small ring on the bottom left

See you tomorrow!

A Very Canadian Tat-a-long 2024

 Hi everyone!

Every year I do a quick tat-a-long for the days leading up to Canada Day.   I have been doing this since 2018 and every year it it seems to work out.  The project is not meant to tat you all day to tat and is just a fun quick project.  There will still be plenty of time to go watch fireworks and parades.  The Canada Day Tat-a-long will be followed by a 4th of July Tat-a-long.  This will occur over the days leading up to the 4th.  I hope you enjoy these projects!

A Very Canadian Tat-a-long Day 1

Vicki Clarke 2024

victats@gmail.com

Terms

R- ring

C- chain

SCMR- self closing mock ring

lj- lock join, where to join is indicated in brackets

lp- long picot

mp- mock picot

dnrw- do not reverse work

rw- reverse work.  I will only note this in situations where you don’t normally reverse work

SLT- shoe lace trick

CTM- continuous thread method, do not cut thread between ball and shuttle

+ join, where to join is indicated in brackets

Materials

Shuttle or needle

White thread

Wind 2 yards on shuttle CTM, needle tatters will use a normal tail.

R             6 lp 6

C             10 p 10

*R          6 + (lp) 6

C             10 p 10* 

Repeat from * to * 2 times to make 4 rings and 4 chains.  Join the last chain to the beginning, tie and cut.

Make 1 motif.

For tomorrow you will need red thread.

See you tomorrow!!!